Introduction

<< Part 1 6. Material of construction of Strainer and Strainer element The material of construction of the strainer and strainer element must be keeping in view compatibility with the process fluid being handled. As a general rule MOC of strainer body is specified in line with relevant piping material spec code and the element material is specified at least ...

Topics covered- What is a strainer What is the requirement of a strainer in a system Identification of Strainers in various documents and preferred location of Strainer Various types of Strainers & their functions Definition of Strainer element and its Basis of Selection Material of construction of Strainer and Strainer element Pressure Rating and End Connection details Layout aspects to ...

Rubber linings are mainly used for protection against corrosion and/or erosion damage. A wide range of rubbers and elastomers are available for lining vessels, tanks and piping. Rubbers can also be made with anti-static properties to give a low surface electrical resistance. Hard rubbers, i.e. hardness greater than Shore D 60, can only be applied by autoclave vulcanization, and therefore ...

Layout arrangement for Centrifugal Pump Piping 1.  GENERAL The design of a piping system can have an important effect on the successful operation of a centrifugal pump. Such items as pump design, suction piping design, suction and discharge pipe size and pipe supports must all be carefully considered. A typical horizontal centrifugal pump installation is illustrated in Fig.CPP1, CPP2, CPP3. ...

SPECIAL SUPPORTING CASES: Few special supporting cases near pumps, tall vessels and exchangers are described as follows: Case – 1: To avoid loading of suction nozzle due to control valve weight, which is nearby, if we provide a trunnion (non insulated as per normal practice) to take weight of control valve, then during operation such nozzle will move up and ...

Table of contents: 1. Why to use a Spring Support 2. Types of Spring Supports 3. Terminology 4. Variable effort spring 5. Types of VES/CES 6. Selection of Variable effort spring 7. Constant effort spring 8. Selection of Constant effort spring 9. General notes and guidelines 10. Points to remember 11. Offshore applications 12. Spring vendors Spring Support 1. Why ...

Classification of Pipe Supports Broadly the pipe supports are classified in three groups as per following details / functions: – General details – Construction details – Functions ie. Purpose These are described below in brief. 1. Pipe Supports Classification as per General Details: A pipe line needs to be supported from a foundation or a structure. The piping loads will be ...

Purpose of Pipe Supports: 1.    Introduction The Piping Profile in general can be considered as a complex and rigid piping network consisting of various piping components, which have different diameters and weights. At the same time the above network is also subjected to temperature change while switching from installed to operating condition (and visa versa) resulting into its thermal growth ...

Requirements for Fasteners The diameters and lengths of stud bolts shall conform to standards ASME B16.5 (for flanges 24” and smaller), ASME B16.47 Series A/MSS SP 44 (for flanges 26” and larger) and ASME B18.2.1. For stud bolts the diameter shall be specified in inches and lengths in millimeters. All nuts shall be of heavy hexagonal type and shall be ...

Piperack or Bridge design flow chart The process of designing a piperack or bridge involves a lot of consideration and co-ordination between different groups in the project. The major groups involve in the development of the piperack or bridge is layout, stress & structural. The initial study begins with layout group which gives the input in the form of 2D ...